Home /Forums /VENDING REPAIR FORUMS /VENDING MACHINE REPAIR /Dixie Narco, Compressor clicks on then off

Error message

  • Warning: ini_set(): Session save handler "user" cannot be set by ini_set() in include_once() (line 144 of /home2/h8o7h9r1/public_html/sites/default/settings.php).
  • Deprecated function: preg_match(): Passing null to parameter #2 ($subject) of type string is deprecated in classified_url_outbound_alter() (line 1755 of /home2/h8o7h9r1/public_html/sites/all/modules/ed_classified/classified.module).

Dixie Narco, Compressor clicks on then off

Notice: Due To Increasing Amounts of Spam:
Links to Outside Websites Are No Longer Allowed
Posts are Now Limited to 2 per day.
Sorry For any Inconvenience.

2 posts / 0 new
Log in or register to post comments
Last post
Sat, 12/25/2010 - 14:38
#1
amrcnmade
Offline
Last seen: 13 years 11 months ago
Joined: 12/25/2010 - 14:33
Dixie Narco, Compressor clicks on then off

Hello,

I Have a Dixie NArco DNCB 168/99-6. HAs been running great. Then suddenly I went for a beer and it was hot. I plug it in and the internals kick on and the fan starts on the inside but the compressor clicks on and then immediatly off. then a few seconds later it repeats. I checked the 3 terminals. Got aprrox .3 ohms on each. Fan in front of compressor does not run at any point. Took fan wire off compressor and still same problems. Any suggestions would be greatly appreciated.

Share page with AddThis
Edited by: fdg123 on 01/03/2011 - 00:18
Top
Sun, 12/26/2010 - 20:03
daryl
daryl's picture
Offline
Last seen: 2 years 9 months ago
Joined: 10/19/2010 - 21:00
Re: Dixie Narco, Compressor clicks on then off

Ok,
When your compressor turns on, the fan should start to run immediatly. If it's not even starting to run then test if the compressor fan is burnt out by running a separate 120v ac line and hook it up to fan wires (disconnect them from the machine first!). If it still won't run then you need a new fan.
Couple of other things to consider. If the fan won't run, the compressor will get hot and it's thermal cut-off switch will kick in and shut it down, it will then cool down and the switch will allow current to flow again and the cycle will repeat.
Also your thermostat might be bad, it's unlikely, but it could be cutting out under load. Swap in a good thermostat and turn it to off then slowly turn it up until the compressor kicks on, if it still kicks out then I would be getting a rebuilt compressor. However, there are a couple of guys on the board here who are able to diagnose compressor internal stuff and maybe they can help you with that.
Let me know if this helped.
Daryl

Top